Subsurface Drip Irrigation Demonstration and Research Project
The University of Arizona

Subsurface Drip Irrigation
Demonstration and Research Project

Department of Soil, Water,
and Environmental Science

About Subsurface Drip Irrigation AZdrip project layout and irrigation Design AZdrip installation of irrigation system Current Crop Results from past crops, project reports

System Design

Irrigation Design

Each original plot was split into two plots to create both an organic and conventional production component. A total of eight 0.31ac (0.12 ha) plots equipped with idependently controlled subsurface drip irrigation (SDI) were established.

Four of the subsurface drip irrigation (SDI) plots (two organic and two conventional) are established as permanent 80" (2.0 m) beds. Each permanent bed contains three drip tubes, spaced 19" (48 cm) apart.

The remaining four SDI plots (two organic and two conventional) are established as variable tube spacing plots and are dependent on the cropping system employed. Each plot may be configured as 40" (1.0 m) beds, each containing one drip tube or as 80" (2.0 m) beds each bed containing two drip tubes, spaced 40" (1 m) apart.

The drip tubing, Netafim® Typhoon (13 mil), was injected at a depth of 9" (23cm) below the bed surface. The drip tubing has a 12" (30 cm) emitter spacing and a flow rate of 0.18-0.25 gal/emitter/hr (0.68-0.95 L/emitter/hr).

The pump/filter station (figure 1 ) is comprised of a 70 gpm (265 Lpm) centrifugal pump, two 24" (0.6 m) Netafim sand filters, a Netfim disk filter, and two LMI Milton Roy Electromagnetic Dosing pumps for chemigation. In order to facilitate independent controll of irrigations and nutrient injections a second delivery line between filters was installed duplicating the master solenoid, metering, and injection ports of the original main line. Each mainline delivery line wired to separate irrigation controllers to maintain independent irrigation control. This set up was important to ensure that the constant acid injection for the conventional plots did not occur during automated irriagation of the organic plots.

Water is delivered to the plots from a pump/filter station via a 3" (7.6 cm) diameter submain to a 2" (5cm) diameter pvc inlet manifold at the south end of each plot. Each plot manifold is equipped with an electric solenoid valve, water meter, and air relief valve (figure 2 ). At the north end of each plot the drip tubing is attached to another manifold to allow for water pressure equalization. Each manifold is also designed with a valved riser to the soil surface for quick and easy backflushing of manifolds and drip tubing.

The drip tubing is attached to the inlet and outlet manifolds using 5/8"(1.6 cm) black poly tubing and compression type fittings.

Figure 1.

Figure 2.

AZdrip pump/filter station
Upcoming and past AZdrip related events The AZdrip Team Sponsors and Contributors Current AZdrip Weather conditions and access to historical data Links to other SDI web sites

Arizona Crop Information Site
Arizona Crop Information Site

Visit the Maricopa Ag. Center



Privacy Statement
document located at: http://ag.arizona.edu/crops/irrigation/azdrip/
Copyright © 2001 University of Arizona,
College of Agriculture and Life Sciences

Search AZdrip and ACIS


For comments and questions regarding the AZdrip site contact: webmanager